SMALTOXYL HYDRO PARQUET VARNISH - VECHRO PAINTS

SMALTOXYL HYDRO PARQUET VARNISH - POLYURETHANE FLOOR VARNISH - VECHRO PAINTS

GENERAL CHARACTERISTICS: PARQUET VARNISH HYDRO is a water based, transparent floor varnish ideal for new and old wooden floors. It enhances the nat ural value and beauty of wooden surfaces, without flaking and cracking. It offers excellent smooth application and fast drying. Due to its special composition, the final surface combines both hardness, providing very high resistance to friction, engraving and water, and elasticity following the natural movements of the wood.

TECHNICAL CHARACTERISTICS:

Texture: Gloss and satin.

Specific weight: 1,04 ± 0,02 kg/lt.

Covering power: 12 -14 m²/lt per layer.

Dilution: Ready for use. If needed, up to 10% on volume with water.

Drying: ½ - 1 hour touch free.

Recoatability: Recoat able in 4-8 hours after application. These times prolong under cold and wet weather conditions.

VOC class: “Interior/exterior trim varnishes and wood stains.” Type WB. VOC limit =130 gr/lt. Max VOC of product ready for use= 129 gr/lt. VOC: organic volatile compounds with boiling point < 250° C.

Taber abrasion: 20mg (cs17/1000/1000).

Shades: Transparent - Colorless.

SURFACE PREPARATION: To ensure proper adhesion of the paint, the surface has to be cleaned from dust, grease, oil, cropped old paints, loose pieces, etc. Sandpaper well before application and remove dust. In case of old painted wooden surfaces, the old varnish has to be removed.

APPLICATION EQUIPMENT: Brush, roller, spraygun.

APPLICATION: Stir well. Apply one or two coats PARQUET PRIMER HYDRO in the appropriate dilution, on dry and absolutely clean surfaces, always on the direc tion of wood grains. When it dries thoroughly, sand with a suitable sand paper, always in the direction of wood grains. After cleaning the dust, apply 1-2 coats PARQUET VARNISH HYDRO at the desired texture. Always stir well before the application.

APPLICATION CONDITIONS: Temperature 8-30°C and relative humidity lower than 80%. The maximum humidity of the wood should not be more than 18% for soft woods and 15% for hard woods. Contrary conditions may degrade product’s quality.

STORAGE: Store in a cool place, protect from freezing and sun exposure. Close the can well after application to keep in good condition.

LABELLING: Smaltolux hydro MASTER PRIMER needs no danger symbols according to EC legislation. More information in Safety Data Sheets (SDS).

SAFETY: Read the tag on the back side of the product. Keep out of the reach of children.

Poison Control Center Number: +30 2107793777.

The polyurethane floor varnish PARQUET VARNISH HYDRO by VECHRO PAINTS is available in 0.75L and 2.50L containers.

NOTE 1: At the bottom of this page you will find the Technical Data Sheet* in greek and english for the product SMALTOXYL PARQUET VARNISH HYDRO - POLYURETHANE FLOOR VARNISH - VECHRO PAINTS.

*TECHNICAL BROCHURE E-8051, DATE OF PUBLICATION 31/07/2018, MOD. 11/09/2023

NOTE 2: For detailed safety instructions, obtain the Safety Data Sheet (MSDS) from VECHRO S.A. Tel. +30 210 48 16 101, www.vechro.gr