CLOU UNIVERSAL-SCHICHTLACK 9200 - UNIVERSAL COATING LACQUER 9200
For open-pore varnishing of wooden surfaces indoors (living-room furniture, children’s furniture, interior decoration). Under normal use in living areas and for sealing parquet, wooden floors, wooden staircases and hand rails. Suitable as a top coat for CLOU AQUA Coating Lacquer.
Characteristics: High quality, transparent, water based one-component lacquer for priming and coating with very good enhancing, filling and sanding properties. Quick-drying, light-fast and resistant to household care and cleaning agents, alcohol and also to plasticiser in sealing profiles. Resistant to creams and hand perspiration.
Environmentally friendly, low odour, NMP-free, free from ophthalmic resin plasticiser (suitable for coating toys). Complies with the VOC Decopaint Directive.
Drying time: (at 20 °C and 50% relative humidity)
dust dry: 30 minutes
recoatable: 2 hours
stackable: 10 days
Cleaning: Clean all tools immediately after use with fresh water or CLOU Cleaner for water soluble lacquers (especially for dried lacquer residues).
Storage/Disposal: Store in well sealed original containers in a cool place protected from frost. Leftover varnish must undergo special treatment and must be consigned to those authorized companies that collect special waste. Recommended waste code according to the European waste directory: 08 01 12 (the final determination must be coordinated through the regional waste utility). Dried lacquer residues can be disposed of in the normal household rubbish. Can be stored for 2 years in sealed original containers.
Safety Instructions: Do not drain into the groundwater or sewage system.
Avoid inhaling spraying mist. If necessary, use appropriate protective breathing equipment (e.g. protective mask with combination filter DIN 3181 A2P3). Even when working with less harmful lacquers, the usual proctective measures should be taken.
Preparation: Sand down the wooden surfaces with 150 to 180 sandpaper and carefully remove dust. The surfaces must be completely dry and free of dust, oil, grease, wax and any other impurities. Woods containing resin should be treated with CLOU Deresinifier before staining. To naturally increase the intensification of the wood tone, the surface can be treated with colour enlivening primer.
Staining: For staining, CLOU® Universal Wood Stain (UHB) products are suitable. The surfaces treated with Universal Wood Stain can be lacquered by brush or spray. All other stains can only be sprayed, as otherwise the stain effect would look smudged. Wax stain should not in general be lacquered over.
Using/Application: (Surface temperature > 15 °C, Wood humidity 8–12 %)
Shake or stir well before use.
Roller or paintbrush: 2–3 applications with a flat brush or roller. Use a short pile mohair or flock roller (super fine) or a paintbrush for water based lacquers. Dilute Universal Coating Lacquer 9200 with 3-5% water if necessary and do not apply too thickly.
Spraying: 2-3 applications (spray one cross-coat normally thick). Caution by airless spraying as the throughput of material is very large – do not spray too thickly! Ensure that all equipment is free from corrosion. Apply Universal Coating Lacquer 9200 as a priming coat normally but not too thickly in order to avoid too much raising of the wood grain.
Drying: (at 20 °C and 50% relative humidity)
After a drying time of approx. 2 hours before the second coating sand lightly with 240 sandpaper. Apply a third coat if necessary only after allowing to dry overnight and sanding with 240 sandpaper. Coatings applied too thickly and high humidity influence the drying. Air circulation (0.5–1.5 m/min.) and a higher temperature reduce the drying time.
Material Texture: CLOU UNIVERSAL-SCHICHTLACK 9200 is available in the following Textures:
- extra matt,
- satin glossy,
- super glossy.
CLOU UNIVERSAL-SCHICHTLACK 9200 floor varnish is available in 1.0L and 5.0L packages.